I use PCZ1000A to an AC power supply (output: 100 Vac). While I am setting the CP mode to 1000 W and when the load current reaches 2.2 A, both the C.C and C.R LED blink and the load current can’t go up anymore. What should I do?

更新2024-3-04

This blinking LED indicates that the other operation mode is activated.
In this case, the CC mode might be set to 2.2 A.
Therefore, the load current is limited to 2.2 A.
Set the CC mode to a larger value.

Bidirectional DC Power Supply

High Power Wide-Range DC Power Supply

Compact Wide-RangeDC Power Supply (CV/CC)

1U Wide RangeProgrammable DC Power Supply

Compact Variable-switchingDC Power Supply (CV/CC)

High-Efficiency, High-capacitySwitching DC Power Supply (CV/CC)

Slim Variable Switching Power Supplies

High-capacity regulated DC power supplies

High Reliability DC Power Supply (CV/CC)

High Reliability DC Power Supply (CV/CC)

Variable Regulated DC Power Supply (CV/CC)

Compact DC Power Supply(CV/CC)

Compact Multi-Output DC Power Supply (CV/CC)

Precision DC Source

Programmable Bipolar Power Supply (CV/CC)

Programmable Bipolar Power Supply (CV/CC)

High Power Intelligent Bipolar Power Supply

High Power Intelligent Bipolar Power Supply

Ultra-CompactAC/DC Power Supply (CV/CF)

Ultra-CompactAC/DC Power Supply (CV/CF)

Compact AC Power Supply

High-performance multifunctionalAC Power Supplies

High-End Multi-type

High-End Multi-type

High-End Multi-type

High-End Multi-type

High-End Multi-type

High-End Multi-type

High-End Multi-type

Standard

Standard

Standard

Standard

Standard

High-End

High-End

High-End

High-End

Regenerative Electronic Load

Multifunctional Electronic Load (CC/CV/CR/CP)

Compact High Voltage DC Electronic Load

Multifunctional Electronic Load (CC/CV/CR/CP)

High Speed-Large Current Electronic Load(CC/CV/CR/CP)

Modular Multifunction Electronic Load

I use PCZ1000A to an AC power supply (output: 100 Vac). While I am setting the CP mode to 1000 W and when the load current reaches 2.2 A, both the C.C and C.R LED blink and the load current can’t go up anymore. What should I do?