| Item | Common to all models | |
|---|---|---|
| Output points | 6 points (Polarity switchable) | |
| Output form | Semiconductor relay output | |
| Selecting function | OFF | Do not use terminals |
| OUTPUT ON | Outputting the signal while the output is ON | |
| POWER ON | Signal is output when power supply is on and output is possible | |
| H ALARM OUT | Output a signal when a HIGH alarm occurs | |
| L ALARM OUT | Output a signal when a LOW alarm occurs | |
| CC STATUS | Output a signal when operating in the CC mode | |
| CV STATUS | Output a signal when operating in the CV mode | |
| SEQ STATUS | Signal is output while the sequence is running | |
| SEQ TRIG OUT | Signal is output while the sequence is running | |
| EXT DIN BUSY | Output a signal when the digital input is in BUSY status | |
| MEM1 ACT TIME | Signal is output when the setting is completed for preset memory 1 | |
| MEM2 ACT TIME | Signal is output when the setting is completed for preset memory 2 | |
| RELAY DRIVE | Output a signal after approx. 100 ms in step with on/off of the DC OUTPUT terminal output. You can set this parameter to only Ch.6. | |
25460
PXT_External digital output
Related specifications : PXT series
- PXT_Lineup
- PXT_Lineup
- PXT_External Control Function-Method
- PXT_External Control Function-connector pin number
- PXT_Bleeder ON/OFF Function
- PXT_General specifications
- PXT_各種機能
- PXT_Communication specifications
- PXT_External digital output
- PXT_External digital input
- PXT_External analog I/O
- PXT_Protection Specifications HIGH alarm
- PXT_Protection function LOW alarm
- PXT_Display
- PXT_400 V three-phase three-wire input
- PXT_200 V three-phase three-wire input
- PXT_Output power
- PXT_Output current
- PXT_Output voltage
- PXT_Output rating
